Customizable Spiralized Labyrinth Gift Box Lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a solid cylinder (minus a small cone) sized to fit over the Labyrinth Gift Box and OpenSCAD Maze things. It…
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 140
- Wydruki
- 1
- Wyświetlenia
- 1686
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Puzzles & Brain-teasers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a solid cylinder (minus a small cone) sized to fit over the Labyrinth Gift Box and OpenSCAD Maze things. It must be printed with "spiralize the outer contour" option checked under the Expert Settings in Cura (or similar mode in other slicers). You might have to play with the measurements/scale slightly depending on your printer and settings. I printed the included .stl at 100% scale in PETG, PLA, ABS, and t-glase since the matching mazes were printed in the same material but if you are going to mix/match (such as an ABS maze with a t-glase lid), you'll probably have to scale the object up or down up to 2%.
After creating this lid, I modified the original OpenSCAD Maze so that it too could be spiralized - see http://www.thingiverse.com/thing:1988537.
Print Settings
Printer:
Monoprice Maker Select
Rafts:
No
Supports:
No
Resolution:
0.25
Infill:
N/A
Notes:
I went for a 1mm thick solid top/bottom but you could go thinner or thicker.
Category: Puzzles