3D Sets Mogster 6x6 Tipper Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A set of parts to add the tipper functionality to the 6x6 Mogster
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
Well, in the same grain as the rest of my mods, this tipper mod for the 6x6 follows the thought process "I love the 6x6 Mogster, but I wish it could dump like the 4x4". And so, it can! Fitted with the same 3 day dumping system as the Model 20 tipper truck, it can now tip behind, to the right and left, with the longer Model 21 Dropside bed. while the bed is quite a bit taller than the stock dropside, the extra height from the bed lift ensures the 6x6 keeps all the articulation in the rear axle and clearance for the tires.
For easy installation, remove the bed off an assembled 6x6 and assemble the tipper bed and tipper mechanism before adding the modified pieces here.
Installation instructions (placeholder until a graphic can be made):
Replace the Model 21 dropside frame with the Intermediate frame pieces, using the same hardware
Install the modified tipper frame onto the Intermediate frame with 4 M3x16
Install and hook up the modified tipper frame and tipper mechanism
Replace the Tipper Floor Front with Floor End Front 32mm for 6x6
Install the bedsides for the 6x6 on the tipper bed
The parts required for the mod are as follows:
All the printed parts in this page
From Model 20: Assembled tipper bed and mechanism (tipper bed, Hinge A+B, floor hinge 4x, piston rod, and piston bed)
Assembled Model 21 without dropside bed
From Model 22: bed frame left+right
4x M3x16 screws to hold the tipper frame to the intermediate frame
All other hardware is the same as if assembling the tipper bed+frame and 6x6 separately.