1 / 10
Asus QG-U1080 2.5g Switch 10 inch rack mount Deskpi rack — zdjęcie 1
1 / 10

Asus QG-U1080 2.5g Switch 10 inch rack mount Deskpi rack

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Asus QG-U1080 2.5g 10 inch rack mount

Ocena
0 / 5
Polubienia
3
Pobrania
36
Wydruki
1
Wyświetlenia
212
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A simple 10" rack mount for the Asus QG-U1080 2.5g Switch, I've used it in a deskpi rack.

There are two pieces, the backing plate is to ensure the router does not move when plugging things in.

The backing is secured with 2 x M3 bolts, I used 8mm length ones, but think around 6mm to 12mm length  should be okay - maybe can get away with 16mm.

There is a hole in the front in case you need to route an SFP+ or Ethernet cable from the rear of your setup.

Print this face/flat side down, I've used tree support to make sure the holes for air vents (sides of the router) came out nice, but it would probably still print without them if your 3D printers bridging is good.

Printed on a Bambu A1 0.4mm nozzle with standard quality setting (.20 layer height) and eSun PLA+ approximately 2 hours for main piece, 15mins for back piece.

Tagi