Drip Tray for Flair Neo Espresso Maker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It catches the drips. It's a tray. It has Flair?
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 106
- Wydruki
- 2
- Wyświetlenia
- 719
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This fits the Flair Neo. There's a less wiggle room than the stock tray. The grate fits in just as a press fit, and it just takes a light pull to remove for cleaning.
I printed it in Creality Black PLA and it's held up really well for the last 5 months. I rinse it off with hot water after every use. I haven't seen any buildup of grossness, so even though it might not be food safe by the strictest standards, as long as you don't drink out of it I think you'll be OK.
Print the grate normally, the bottom has a nice sheen so I keep that side face up.
Print the bottom with supports. I used ironing, but IDK if that made the buildup any better.
I think it'd look really well with some space grey PETG or maybe some red to give it some flash and match the portafilter.