2018 Subaru Outback MagSafe Phone Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Works with 2016-2018 and likely others.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 211
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I absolutely hated other cellphone holders that mount on vents within the car. I didn't want anything on the dash. There is handy little pocket, but it's not well positioned or oriented to permit charging.
Therefore, in my migration to magsafe chargers, I developed a magsafe charger that fits within the original phone pocket. It's slightly larger than needed so it permits older and/or larger phones. I used iphone 12 and 13 and it works on the 15 as well. It's partially angled to face the driver. It allows you to swing the phone to portrait mode if you're in the car waiting.
I printed in PLA and over the years it started to lean backward a bit. Not a big deal, since it would just lean against the console if phone in portrait mode. You could tweak the model to add a model rod to prevent any warpage. Or just reprint =)
The fit into the pocket should be a bit firm. I printed in 35% and never got around to doing 100% infill. As a result, it was a bit top-heavy. You could bump up to 100%, and/or use some BluTack (or alternative that allows to adhere it into the pocket). I didn't and simply stuck some extra paper into the pocket which was good enough for several years.
The model permits off-the-shelf magcharger to be used. It's a tight fit for the magnetic disc and I never felt a need to adhere the disc to the model. That permitted me to grab the charger if needed if I show up somewhere and didn't have another charger to take with me.
Sadly, I sold my Outback but wanted to give back to the Subaru community.