KitchenAid food processor Adaptor W11736465 (for the stand mixer version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a model for the food processor attachement for the stand mixer.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
this is a model for the food processor attachement for the stand mixer. We lost ours, and I reproduced it from photos and measurements from the other parts.
It is a good fit and works.
the fusion model is there, along with TWO different STL:
one that you print as is, with supports (not recomended due to overhang rough finish and food contact),
one to print in two haves, and join with glue (and locating pins made of filament.
If you print the one where the part is in two halves, use short (around 2-2.5mm) locating pins made from 1.75mm filament in the series of holes, to make certain the part is well aligned. ONE of the holes is slightly bigger than the others, so that if they are too tight and you don't have a 1.75mm drill bit, at least one should fit. I suggest you use epoxy for glueing it, to fill any potential gaps, and use clamps (lightly) to keep it tight while is sets.
I made mine of PLA. haven't used it much, but I suspect it'll be fine.