TEVO Tarantula X tensioner belt holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Osiak's X belt tensioner works really well but the original belt holder lifts the belt by about 5mm. This causes…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Osiak's X belt tensioner works really well but the original belt holder lifts the belt by about 5mm. This causes inaccuracy in x movement as the belt becomes a hypotenuse in a right angle triangle and thus the actual carriage movement is less than the belt movement. The amount of inaccuracy changes depending on how far the carriage is from the edge.
This replacement belt holder lowers the belt to so it is parallel with the x axis. It also allows the adjusting bolt to move further as it is offset from the belt.
This is the belt holder only. You need the clamp and carriage piece from the original
which you can get at https://www.thingiverse.com/thing:1748326
Edit: Recently adjusted a little too tight and my belt holder broke. V2 is a little thicker and the sides extend further up . It should be really strong now.
Category: 3D Printer Parts