DIY resin wash station for GA25-370 DC motor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple wash station made from a 12v DC motor and some other components I had laying around
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
A simple wash station made from a 12v DC motor and some other components I had lying around that I bought at AliExpress at some point.
The DC motor I bought was the GA25-370 - 280 RPM / 12v, and it does seem plenty fast enough for this. Could probably even use a lower rpm and get away with it tbh, same name as this one https://s.click.aliexpress.com/e/_c3JbVEKf
I also used a CS07 Motor controller like this one: https://s.click.aliexpress.com/e/_c4DhNdF
Also, plug's for the power connector: https://s.click.aliexpress.com/e/_c2uflbWj
I also used 10x3 magnets or well mine measure a little less, idk why, but it's more like 2.8 ish. well, I still think these would be roughly the same: https://s.click.aliexpress.com/e/_c3Y8wIdN
and 14 x M3 x 8mm screws/bolts: https://s.click.aliexpress.com/e/_c4On0aGF
I just screwed the bolts straight into the plastic, but you might be able to use heat inserts if you prefer that.
And that's it.
I barely tested it yet, but it seems to work pretty well.
If you run into any issues or need a spacer or something, just tell me and I’ll see what I can do.
I printed everything in PLA because it’s the cheapest and fastest material to use for prototyping, so I’ll keep using it until something breaks, if that ever happens. Then I’ll reprint the parts in other materials, probably ABS for the impeller and maybe PETG or ABS for the rest in case of heat buildup, though I honestly don’t think that will be an issue.