1 / 6
Tongs/Grabber - Scissor Type - 3 Versions (plus Left and Right Handed) — zdjęcie 1
1 / 6

Tongs/Grabber - Scissor Type - 3 Versions (plus Left and Right Handed)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A scissors style tongs/grabber with three styles of "jaws."

Ocena
0 / 5
Polubienia
5
Pobrania
24
Wydruki
0
Wyświetlenia
154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Public Domain

This set of tongs can be fitted with any of three sets of "jaws," depending on your requirements (see photos):

  • scoop

  • flat

  • basket

This model requires a #10-32 X 1/2" round head screw and matching nut for use as an axle.

I made this to go along with my "poop scoop" - which works, but I thought could also use an additional "hand." See the link below :

https://www.printables.com/model/1710410-poop-scoop-indoor-with-spatulascraper

The "scale tag" you see in the photos can be found here :

https://www.printables.com/model/1710483-scale-bartag

Assembly and Use

 This set of tongs is modeled on a very nice set of scissors I have (see photos), which have a very comfortable right hand grip. For you lefties out there, I mirrored the handle pieces so you can just print those.

You will need to print out each of the two handles, as well as two copies of whatever style of jaw you want. 

Assemble by placing the two handles together as shown in the photos, and insert the screw through the axle holes. Fasten the screw with the nut, and adjust the nut tension for a tight but smooth connection. Apply a small drop of super-glue on the end of the screw to lock the nut in place.

The jaws are a press-fit onto the handles. Note that the ends of the two handles are offset, so the jaws are also to compensate. Make sure you have the jaws fitted on the ends the right way round (they should line up), and then press them firmly into place - no glue is needed.

Print Instructions

Print in PETG using the 3mf files provided, otherwise :

  • 0.2mm layer height

  • 3 perimeters

  • 15% rectilinear infill

Note that the blade pieces must be print "flat side" down.

I used PETG because I want to be able to wash the tongs in very hot water, but if you don't have that requirement, then PLA should work.

CAD

The OnShape 3D CAD files for this are here :

https://cad.onshape.com/documents/d5c113d5847b11ea9f7e2f1b/w/7fe50ac41f190791a283352e/e/5636d2b7562aaf4b004d6be6?renderMode=0&uiState=69fbcb58173725acbf836ff8