Bigtreetech SKR Pico v1.0 Case rev 2 w/ RPI 4B
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bigtreetech SKR Pico v1.0 Case - top and bottom. 3mm screws for case, use screws that came with board for mounting.
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 673
- Wydruki
- 7
- Wyświetlenia
- 3988
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
::edit:: added images of both revised cases printed and mounted stacked with spacer between. rpi case has btt pi4b and cb1 mounted inside (fits perfect but doesn't have headphone jack) and the pico case has a pico board inside as well. so all fit nicely and should be gtg.
-------------------------------------------------------------------------------------------------------
::UPDATED 11/20/2022:: Cleaned up the SKR Pico case a bit, added a case for the Raspberry Pi 4B and spacer to go between (17mm, though if higher is needed let me know and I'll size it up more).
Attempted to keep these along the same theme so that they'd match in style. Haven't printed the updated versions yet, and don't have an Rpi4b to test that case out with. Print out updated cases at own risk, not responsible for wasted filament/time if they don't work.
Removed face inside of case, added labels. Updated files are listed as rev 2.
-------------------------------------------------------------------------------------------------------
Went looking for a case for this, and there were very few if any out there. So I designed this one.
Printed out in the colors shown (black for top, silk green for bottom). After a few errors in spacing for the mounting screws on the bottom and the “window” spacing on the top section, I'm happy with the results.
The face on the bottom is a selfie of sorts. If requested I'll post a copy without that there.
Use m3 screws for the outer case (they're snug but not tight, I went from the bottom up as I didn't have long enough screws), and use the screws that came with the board for mounting to bottom plate (tight fit but works fine).
I'm thinking of making a set of stand offs to add the rpi case below it, but nothing concrete as of yet.
Thanks for looking!
Made in tinkercad, printed on ender 3 pro, standard settings in cura (print thin walls turned on), no supports needed when set to flat faces on the print surface.
Not for selling, but free to share and mod all you'd like.