Simple bumper case for Pebble Time 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Very quickly-designed protector for the Pebble Time 2 smartwatch.
- Ocena
- 5 / 5
- Polubienia
- 60
- Pobrania
- 591
- Wydruki
- 2
- Wyświetlenia
- 2412
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This was made by modeling a simple outer geometry, then subtracting a slightly-enlarged mesh of the watch from the official Pebble repo. This was a quick and dirty lunch-break project, so there is a lot of room for improvement I'm sure.
Print shown was printed in PLA on a Creality K1 at 0.08mm layer height. Printed in the face-up orientation shown with supports on.
UPDATE: "v4" is a revision with slightly thicker walls so more slicers should be able to handle it without holes in the sides. I also made the face more symmetrical, and tidied up the bottom of the button cutouts.