KlickFast Dock for Radio Loop

Remix of robo-w's KlickFast Dock

This remix adapts the KlickFast system to securely mount a body camera / radio to the radio loop on a shirt. The design is compact, low-profile, and intended for everyday use where a reliable attachment is needed without adding unnecessary bulk.

Design Features

• Slim opening slides onto the shirt’s radio loop

• Tight-fitting slot helps prevent movement or accidental detachment during use

• Secure enough for active movement while remaining easy to remove when needed

• Compact design stays unobtrusive when no camera or radio is attached

• Fully compatible with the KlickFast quick-connect system for fast attachment and removal of body camera / radio 

Size Variants

I made several iterations while perfecting the size for my shirt. I’ve uploaded all the versions I still have so others can hopefully find one that suits their shirt.

V1

• Slot length: 29 mm

• Slot width: 2 mm

• Opening: 2 mm

V2

• Lost the file...

V3

• Slot length: 27 mm

• Slot width: 2 mm

• Opening: 2 mm

V4

• Slot length: 26 mm

• Slot width: 1.5 mm

• Opening: 1.5 mm

V4 fits my shirt perfectly with virtually no movement once installed. It takes slightly longer to fit and remove, but the tighter fit makes it worthwhile.

Printing

I recommend printing the model on its side, as shown in the photo below.

Recommended settings:

• Tree supports

• Supports touching build plate only

Other settings I used:

• PLA

• 15% infill

• 2 wall loops

I haven’t had any durability issues so far, though PETG would probably be a better option for long-term use. The PLA version I use daily has now split. I’d recommend printing in PETG, especially if you’ll be mounting and removing the camera or radio frequently. I will update further if I experience more issues.

Since this is quite a niche design, I’d really appreciate any feedback if you end up printing or using it.