Guitar Hero Guitar Wall Mount (adhesive strips)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for guitar hero guitars that uses Command adhesive strips for mounting.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Uses medium-sized command adhesive strips (the same kind that are used for wall hooks). Designed such that the mounting point is separate from the hanger so the strips are hidden while the hanger is mounted, but the strips can still be removed easily later. You might want to trim the bottom portion of the strip so it's fully hidden when the hanger is attached.
Printed in ASA with 3 perimeters, 5 top layers, 4 bottom layers, 25% infill, and supports enabled. I'd recommend not printing in PLA, otherwise there's a decent risk of the connecting portion breaking off. Print in the default file orientation for the best strength (you could rotate the mounting plate by 90deg so the layer lines are parallel to the mounting flap if you really wanted to).
Follow the adhesive strip application instructions closely and test the hanger for a bit before hanging a guitar to minimize the risk of it falling. It's been fine for me so far but use this at your own risk.