3d printable toothpick frame 3 inch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d printed 3 inch toothpick frame, supports 25.5x25.5 stack boards. Works with
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 176
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
When i started this hobby, I always wanted to 3d print my own drone. This is a very simple and lightweight 3 inch toothpick frame that works super well with all in one boards.
Parts :
Filament used :
-for a minimum strength, PETG-CF or stronger (PA12-CF or PA6-CF),
-40% infill gyroid,
-3 to 4 perimeters.
Fasteners :
-2mm screws,
-20-25 mm length,
-2mm hex nuts,
-2mm silicone dampeners,
-For a Canopy, I used the Vision40 canopy by RotorRiot, it should be in Printables.
Electronics :
-25.5x25.5 AIO all in one FlightController, 2-3s 15A minimum,
-1303 -1204 sized motors, 2-3s, i used 1204 happymodel 8000kv motors, works well,
-Any 3 inch tri-blade propellers,
-For a vtx, any small 25.5x25.5 board will do, i used the walksnail 1s mini lite, it worked perfectly,
-For a receiver, it has place in the canopy to sit in, I used an EP2 receiver,
-XT30 plug and 18-16 gauge wire for power. 15V 250-400ish uf capacitor will do just fine.
Battery :
2s or 3s lipo battery, from 450-550mah, I used a thin battery strap that loops underneath the frame.