1 / 3
JST XH (LiPo Balancing Port) Protection Cap — zdjęcie 1
1 / 3

JST XH (LiPo Balancing Port) Protection Cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is my take on a protection cap to prevent short circuits and dusty contacts on my LiPo batteries.

Ocena
5 / 5
Polubienia
32
Pobrania
150
Wydruki
2
Wyświetlenia
1035
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I was not satisfied with the existing battery (balancing port) protect solutions out there (neither flexible nor solid ones) so I designed my own protection cap to fix this issue for once and for all. 

You might have to slightly reduce the line with setting depending of your slicer (In my case CURA) to get better results and less travel moves. The walls are designed with a width of exactly 1.2mm but my slicer seems to have a bug where it would not fit three 0.4mm walls in this wall width…

I included the .stp files so you can resize the cap as needed (slice the model in the middle and add or remove 2.5mm for every additional pin) I hope this model will end your struggles as it did mine.

Tagi