Mechanism's Steam Controller Dock with Penny Weights and Hot Glue Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modded Mechanism's Steam Controller Dock to include penny weights, hot glue feet, and thinned base for faster printing.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 88
- Wydruki
- 1
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is Mechanism's Steam Controller Dock, but I have modded it to accept 50 pennies at the bottom as weights, 4 small holes to use for hot glue feet, and reduced baseplate thickness to accommodate for the extra weight added by the pennies. (non-copper pennies will be around 126g total added weight.
For the hot glue pads to round well, squirt HIGH TEMP hot glue into the 4 small holes while the dock is upside down, but don't worry about trying to make them look uniform. Keep the dock upside down for about 3 minutes and the glue will naturally settle into a convex shape, and you will have your sticky feet! If it didn't work, wait or it to cool, then peel the whole thing off and try over! (This method will give the look of the dot on the bottom-right)w
For the pennies; Each slot holds 5, but are pressure-fit when the last penny is placed in each slot. You don't need all 50 pennies, but you do need them in increments of 5.
My printing parameters
- 3 Walls (0.4mm nozzle)
- 12% Rectiliniear / Gyroid infill
- 5 top and bottom shells
- [Optional] Alternate Extra Wall - ENABLED (This helps with the structural integrity of the pole for the dock)