Stackable Storage Box 184x184x60mm with ventilation

Motivation

[ storage boxes for tomato ripening ]
During a vacation in France I bought fruit in nice stackable wooden boxes, which I now use for ripening tomatoes on a window sill.
As the boxes are stackable, only little space is required.

[ ensure good ventilation of contact region ]
To avoid early fruit spoilage, I wanted to ensure good ventilation of stored items in the contact region at the bottom of the storage containers.

After designing the ventilation grid for storage boxes (link below), I also needed a solution for the stackable storage boxes.

Solution

I derived a 3D-printable design based on the wooden storage boxes.
This way, everyone can simply print the boxes if needed.
Additional ventilation grids in the side walls enable good ventilation (and save material without sacrificing stability).
The design allows printing without brim or supports, which generally results in better surface quality, especially when printing with PETG.
 

Print

Printed with SUNLU PETG (Coffee).

  [ storage box side walls type A ]
  2x StackableStorageBox_SideA_v00.stl
     (support:                  not required)
     (brim:                       not required for satin)
     (print orientation:   inner face down)
     (colour:                    Coffee or as you like ;-)
 
  [ storage box side walls type B ]
  2x StackableStorageBox_SideB_v00.stl
     (support:                  not required)
     (brim:                       not required for satin)
     (print orientation:   inner face down)
     (colour:                    Coffee or as you like ;-)
 
  [ storage box base plate ]
  1x StackableStorageBox_BottomSolid_v00.stl
     (support:                  not required)
     (brim:                       not required for satin)
     (print orientation:   inner face down)
     (colour:                    Coffee or as you like ;-)
 

Assembly

[ Storage Box Setup ]

[A]
Place the "storage box base plate" on a flat surface.

[B]
Clip the "storage box side walls type B" onto opposite sides of the base plate.
The 3 noses of the base plate fit into the related horizontal slots of the side wall part.
Make sure, that the even surface (print sheet side) faces inwards.

[C]
Clip the "storage box side walls type A" onto the unused sides of the base plate.
The 3 noses of the base plate fit into the related horizontal slots of the side wall part and the 3 noses of the side wall type B should exactly fit into the vertical slots of the side wall.
Make sure, that the even surface (print sheet side) faces inwards.

All done!

Store & Enjoy!!!