1 / 5
Case for Gadec Departure Board - ESP32 D1 mini and 3.12" OLED — zdjęcie 1
1 / 5

Case for Gadec Departure Board - ESP32 D1 mini and 3.12" OLED

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Alternative case for Gadec's mini departure board project.

Ocena
0 / 5
Polubienia
7
Pobrania
45
Wydruki
0
Wyświetlenia
247
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Provided case was boxy, so I wanted to enhance aesthetics - taking inspiration from the Braun DN40 and Scott Yu-Jan's subsequent iPhone dock. 

Original case required soldering to the display header pins and the ESP32's PCB directly. This one has enough room to use 10cm jumper wires with DuPont connectors. This allows for quicker assembly and non-destructive disassembly if needed.

I will upload the Fusion file once I have tidied it up. Tolerances only tested on one printer - so please do provide feedback if printed. I used 3 perimeters, 0.16mm layer height, PETG or PLA. Supports are needed, but only for the area inside the case where the board sits and a small amount for the front roundover. Please see 4th picture.

Case back friction fits tightly into place and pushes the display against the front bezel, which is already aligned on mounting pins. TTP223 Touch sensor can be taped against the side of the case, as shown in picture 5.

It is an amazing project with a superb level of polish from the orignal creator. Find the build instructions here: https://github.com/gadec-uk/departures-board