Giant Brightbloom Seed from Zelda : Tears of the Kingdom with insert to hold light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This version is meant to use a 4" round led light base and is designed with a slot for the cord.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I liked the original Giant Brightbloom lamp a lot, but I felt there were some tweaks to be made in the installation of the light source. This version is meant to use a 4" round led light base and is designed with a slot for the cord.
I printed my leaf in PETG and the seed in glow in the dark PLA. I used this light https://a.co/d/06LG2eQ7, used cyanoacrylate glue to hold the pieces together better, and used electrical tape to block light out of the cord slot and the seams between pieces.
I've included both a .3mf that includes all pieces with my print settings, and a .stl for just the insert that I added to the original design for anyone who has printed that already (note: to add my insert, you need to be able to separate the top and bottom leaf pieces still).
This is an easy assembly:
Place the seed inside the upper leaf piece
Thread your light through the hole in the light insert base. If you purchased the light I linked above, this should fit fine as long as you depress the button on the cord, otherwise verify that your cord fits
Place the light insert inside the lower leaf piece and push down (the light insert should slightly stick out the bottom). I used CA Glue to hold this piece in place
The light should fit in the circle, you can glue this down or just tape down with electrical tape
Place the pegs in the lower leaf piece with the "U" showing (I used a bit of CA Glue to better hold these into place))
(Optional) use electrical tape to block off the seams between pieces
Attach the top leaf to the bottom leaf by aligning the pegs. You can use glue here as well, I didn't so that I could take it apart and get at the electrical tape and light if I needed to change anything.
