O-Ring and small parts organizer boxes for Plano 3771-00 CDS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organizer boxes fit Plano 3771-00 Custom Divider Series organizer.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
I got tired of my O-rings migrating under the removable dividers and created these boxes to fit this Plano tackle/organizer box. I'm using these to organize o-rings and small parts in my paintball toolkit, but they could be used for just about any small items.
The tabs on the lid retain it into the box, and are fairly aggressive in doing so. To ease assembly, you may find it helpful to break the sharp corner on the lid's retention tab with a bit of sand paper. When assembling these it is easy to crack the box at the thin spot in the "finger groove" area. It is helpful to insert the side opposite the finger groove first and push the lid away from the finger groove so you are not putting much force on that side. Print a few extras and experiment with the assembly technique.
It is also important to note that the fit of the lid to the box is very tight at first. You'll slide it back and forth and it will be really difficult. However, once you work it back and forth a few times it will loosen up and slide nicely. When I had the fit dialed in perfect right off the printer they quickly became sloppy loose.
I printed these on my Bambu X1C in PLA with .4mm nozzle. The boxes should be printed in the same orientation as they sit in the organizer with support for the "roof" of the box. Standard support or tree support both worked well, but the tree support is much easier to remove.