Van Arkride stun kaliber

I made this model based on the weapon Van Arkride uses in the game Trails through daybreak.

It is completely cut up in parts so that everything can be printed in the correct colors. 

My personal one has all the black blade parts printed in 95A TPU just to honor the type of weapon it is.

Hardware

For complete assembly it requires 2 M5 thread size rods. 

• 118 CM round M5 or anything below 6mm.

• 94,5 CM round M5 or anything below 6mm

These are pure for structure throughout the whole weapon. If you just want to hang it without it will work fine.

Printing advice

I tried to model it in such a way that the amount of support needed was kept to a minimum

Some models do require some support to be printed correctly i always used tree supports:

• back cover blue V1

• Cilinder blue body V1

• Handle blue sleeve V1.1

• Main handle blue top V1

• Main handle dark metal V1.2

I used a brim for the following parts:

• All the black blade parts.

• Handle side cilinder blue 2x V1

• Main handle dark metal V1.2

• Side cilinder gold 2x V1

Printing amounts

The amount for most models is just a single piece, the ones that require you to print more will indicate this in the name.

For assembly:

Assemble the complete handle including the first blade piece before putting in the threaded rod.

Extra information:

The weapon is extremely poorly balanced because of the design. So keep this in mind when expecting to swing it around.