1 / 2
Height-limited fan duct for MKS Gen L V1.0 Stepper cooling — zdjęcie 1
1 / 2

Height-limited fan duct for MKS Gen L V1.0 Stepper cooling

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I'm running a JG Aurora and want to update the stepper drivers to TMCs, which require active cooling. I bought a 60mm…

Ocena
0 / 5
Polubienia
4
Pobrania
28
Wydruki
0
Wyświetlenia
249
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

I'm running a JG Aurora and want to update the stepper drivers to TMCs, which require active cooling. I bought a 60mm Fan only to find out afterwards that I only had 5.0-5.5cm clearance for it.

So I designed this part. The long neck can be placed over the stepper coolers and the fan just slides onto the 4 poles. This is NOT flow-optimized, however I believe that the raw amount of air pushed around by the fan should be sufficient to cool the steppers even with turbulences.

2021-04-25: Update: I finally came to installing it myself and I can tell you: It fits in the JGAurora A5 but you will need to carefully route the Heater Bed cables so they don't run into the fan

Print Settings

Printer:

JGAurora A5

Rafts:

No

Supports:

Yes

Resolution:

0.3

Infill:

N/A

Filament:

Goedis PETG

Transparent Green


Notes:

The gap of the shaft is only 16mm, so you don't need support for this (bridging should work). I placed a support blocker into the shaft in cura so that only the support for the walls is generated. Saves a lot of time and hassle trying to get the support out of there :)

Category: 3D Printer Accessories

Tagi