Table mount for holding rod for streaming light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed something that could securely hold the pole of my stream lighting equipment. Up until now, I used a pair of…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed something that could securely hold the pole of my stream lighting equipment. Up until now, I used a pair of locking pliers to prevent the rod from falling over but that took away a lot of space under my screen podium.
This holder is designed to be screwed into the podium by 4 screws. The rod holder will extend under the podiumby around 8 cm, so make sure you have enough clearance.
Print Settings
Printer:
JGAurora A5
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
100%
Filament:
Goedis PETG
Transparent Green
Notes:
The Rod holder needs support so the screw hole is printed nicely. Make sure to have ample space between support and the inner wall (I used 3mm as Support distance). Then, WHILE STILL WARM, take the part, screw a screw halfway into the bottom hole, then hit the screw on a hard surface. This will break the support pillar free and you can safely remove it without damaging the actual part.
Category: Office