Trombone Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was searching for a cheap trombone stand for my son he could leave at his school and would not have to carry with…
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 143
- Wydruki
- 0
- Wyświetlenia
- 1037
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
I was searching for a cheap trombone stand for my son he could leave at his school and would not have to carry with him all the time.
We used a wooden dowel 20mm for the stem and for the legs.
you will need :
3x lover cap
1x upper cap
1x bell rest (V01 from the source or V03 (copied that from the K+M stand we own) as you like)
1x wedge to secure the bell holder
1x joint
the measurements are approximately 30cm for the feet and 70cm for the stand.
The holes for the legs tend to be a little tight because of the droop at the very top.
I tried to clear them with a 20mm drill bit, but that split one of the connectors, so I would reccoment to sand that part clear rather than trying to drill it.
I would also advise to print one of the endcaps first to check if it fits your material.
Category: Music