Skateboard/Deck wall mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for bare skateboard/decks.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Wall mounted holder for bare skateboard/decks. 2 different versions.
1st version used 4 - 5mm heat-set inserts and 4 5x20mm screws.
2nd version uses 4 - 5mm nuts which are placed during the printing process. You will want to pause your printer at line 270, insert the nuts then resume. You'll either need 5x20mm screws or 5x25mm screws. If using longer screws, may need to use washers as to not break the mounts.
Deck pictured is using the first set of mounts, printed in PLA 4 walls with a 25% infill. to prevent the extensions from breaking off, a higher wall count is needed. minimum 4 walls.
Rotate the item on your build plate so it prints the opposite of how the board will be mounted.
Please be sure to not to pull on board/deck when mounted. These should hold a deck up fine, but if any additional weight is applied in a downwards manner, they will most likely break.
Being indoors, PLA is fine. That said can print in ABS, PETG, ASA, etc. Just be mindful of shrinkage. 5mm nut I used is 7.9mm flat to flat, and 8.9mm point to point.