1 / 13
Mini Monitor Stand (7" - 10") — zdjęcie 1
1 / 13

Mini Monitor Stand (7" - 10")

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mini monitor stand to go with my mini pi desktop.

Ocena
0 / 5
Polubienia
26
Pobrania
73
Wydruki
0
Wyświetlenia
1370
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

A mini monitor stand to go with my mini pi desktop. https://www.printables.com/model/172093-mini-pi-desktop-tower

Check out my mini lamp to complete your mini gaming desk

https://www.printables.com/model/172095-mini-desk-lamp

 

you will need:

  1. a 1 inch outside diameter pvc pipe. for my dual 7" monitors i cut it to be 7" tall, but this is up to your preference (within reason)
  2. 1/4" by 1-1/4" screws and nuts. (number depending on the setup you choose) (m6 might work as well)
  3. 1/4" nylon washers, to go between the "Arms" and the "Brackets", one on top and one on bottom. (if you want to skip this, just scale the height of the arms to 18.5mm, and smooth them out a bit and it should work, but i liked the smoothness of having nylon washers in there.
  4. a single #4-40 3/4" screw and nut for the center bracket. (m3 might work, but you will probably need to scale the knob up a little.

I'm guessing any monitor with that slide bracket on the back will probably fit this, but i have only tested with the below monitors.

https://www.amazon.com/gp/product/B06W5WB26H/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1

I have made this to be modular. I used two 7 inch monitors, but with the parts included you can do 7 or 10 inch, probably more sizes, and 1, 2, or even 3 monitors. I suppose with a longer pvc pipe, you could even do 4 or 6 if you really wanted, but at that point i think you would just be using a regular monitor. (although i would love to see a six 10 inch monitor setup, lol)

you can see in one of the pictures a "two 7", "three 7", and "three 10", setup as examples.

there are 2 different center brackets, one with and one without a monitor mount. the one without is for a dual monitor setup, the one with is for 3. There are 2 lengths of arms for 7 or 10 inch monitors. The small knob is for the back of the center bracket, to tighten it against the pvc pipe. and the large knob is for screws that hold the brackets and arms together.

I printed everything with 10% infill. The arms seem to handle this fine, the monitors are not very heavy, but the brackets flex a little. you may want to up the infill, or even go solid, it wouldnt take that much filament to do so.

i realize i could have oriented the brackets so they would not require supports, but i wanted the layer lined to run they way they do for added strength. so i would suggest printing everything as it sits, and use supports.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

Yes

Resolution:

.32

Infill: 

10

Filament: PolyMaker PLA

 

 

 

Category: Computer

Tagi