1 / 3
Saxophone and Clarinet Ligature, fits all saxes. Mouthpiece Labs — zdjęcie 1
1 / 3

Saxophone and Clarinet Ligature, fits all saxes. Mouthpiece Labs

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Saxophone clarinet ligature, fully printed and adjustable. Size customizable to fir any instrument

Ocena
5 / 5
Polubienia
16
Pobrania
134
Wydruki
1
Wyświetlenia
392
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
Creative Commons — Attribution — Share Alike

Customizable Ligature that fits all saxophones and clarinets

Thumbscrew and plate ligature. Fully 3D printable requiring no additional hardware. 

Premade sizes are included for hard rubber Soprano, Alto, Tenor and Baritone mouthpieces. 

Use the customization feature for all other instruments and sizes, including all clarinets and metal mouthpieces.  

Visit https://mouthpiecelabs.com/ for custom saxophone mouthpiece models!

Print settings:

0.12mm layer height or finer. 4+ walls, otherwise default

No supports needed

Enable brims only if the print detaches without

Assembly instructions:

  1. screw the thumbscrew through the threads all the way in 

  2. align the hole on the bottom of the reed plate against the ball on the screw. Press the on the plate (might require some force) until the ball snaps in

  3. turn the screw to make sure all parts move

 

Customization:

You can make the ligature in any size you want in 2 ways:

  • Download lig.fcstd and edit Primary and Secondary variables in FreeCAD

  • Download ligature_parametric.scad and edit the Primary and Secondary variables in OpenSCAD

The primary parameters are what makes the ligature fit your particular mouthpiece and reed:

  1. Front diameter: the outside diameter of the mouthpiece, measured at the point where the ligature begins.

  2. Front height: The vertical distance from the top surface of the mouthpiece to the bottom surface including the reed, at the same location as the front diameter.

  3. Back diameter: the outside diameter of the mouthpiece, measured about 15mm behind the front diameter. If you choose to customize the ligature length, move back your customized length from the front diameter.

  4. Back height: Front height: The vertical distance from the top surface of the mouthpiece to the bottom surface including the reed, at the same location as the back diameter.

  5. Reed width: the width of the reed at the end of the vamp

You can also vary the following secondary parameters:

  1. Wall thickness: the thickness of the ring that goes around the mouthpiece

  2. Screw rad: the size of the screw and screw hole

  3. Lig length: the length of the ligature.

  4. Small knob/Knob radius: makes the knob smaller (OpenSCAD) or whatever diameter you choose

Tagi