Retevis RT3S / TYT MD-UV380 SP/MIC (speaker/microphone) replacement port cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remake adds a nose to aid in installation.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 69
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I tried installing the original version and after 10 minutes had not gotten it in. I decided to add a long nose piece to aid in pulling the the locking piece into the case. Worked perfectly with a pair of hemostats then cut it off with a pair of side cutters.
Make sure not to cut too close to the case when trimming it off.
The remaining instructions are from the original except for the updated install piece:
I recommend printing it in TPU (95A), with no supports. If you have a rough textured PEI bed sheet, the look of the replacement part will look like the rest of the radio, which is a bonus.
The fit is snug like the original cover, if not better. To install the cover you will need to disassemble the radio by removing the antenna, the volume knob and the channel select knob, by unscrewing the brass rings that hold the antenna connector, the volume potentiometer and the CH select knob, then by taking out the two screws at the bottom, and finally by prying the radio open with a spudger of a flat screwdriver. Be careful because there are a few flat flexes and cables to disconnect, so watch a video on YouTube before attempting this installation/replacement. Once you opened the radio, you will need to place the replacement cover in place and pull on the insertion tab until it snaps in place. Then use sisters or similar cutter to trim the long tab off,. Make sure to cut close to the case but be sure to leave the locking tab in place.
You can now reassemble the radio.