NAVEE GT3 LOCK-CHAIN HOLDER
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I tested this print for about a month now and can say I liked it so much i would like you to try it too!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Throughout my Navee riding journey, I kept my lockchain wrapped in a spiral around the steering tube. Over time, this became increasingly frustrating — the lockchain constantly interfered with the folding lever, especially when I needed to quickly collapse the scooter to get on a bus or store it. Yes, you can keep the lockchain in a backpack, but I don’t always ride with one.
So, I’d like to introduce the Navee GT3 Lockchain Holders. These holders are designed to fit around the almost square tubing that connects the main frame to the steering column.
Hardware Required
3 × 3.6 × 150 mm zip ties (as shown in the photos)
Printing Instructions
Print Hook A and Hook B × 2.
You may need supports for the small “flap” guide — use manual supports to prevent the slicer from closing the zip‑tie holes.
Recommended materials: PETG or ABS/ASA (My own set is printed in PETG.)
Installation Notes
Refer to the photos for installation guidance. Before tightening the zip ties, position the hooks far enough apart so the lockchain fits snugly between them. Once you’re satisfied with the spacing and tension, fully tighten the zip ties.
The lockchain may feel slightly loose at first, but in my experience it stays securely in place — even on dirt roads.
If you’d like to tweak or remix the design, feel free to explore the Onshape link.
https://cad.onshape.com/documents/a079be4c7c44e4728e2b7009/w/9b5d9f54e3464572446d3ea2/e/847d11c658913619e12e6aa7?renderMode=0&uiState=6a06132da37a177b9db3922d
Thanks, and enjoy!