Ruger Precision Rimfire Adjustable Stock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A length-adjustable, low stock for the RPR
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 178
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Very adjustable length ways, the included shoulder piece goes down much lower than the standard stock. This is due to my 22 shooting stance: the scope is mounted on a high cantilever, I bring the rifle to my eye and I don't hunch down, preferring a relaxed shoulder. This requires the shoulder stock to go down very low.
There are two included bases, one longer (bronze) and one shorter (red). The shorter one you print twice and the holes should match up.
There is also a shoulder covering that I printed in blue with a fuzzy surface to make it a little grippier on the shoulder. I suppose one could print the shoulder part fuzzy to start off with, but the extra covering was an afterthought.
The rifle in the picture without the blue shoulder covering has a length of pull of 31.5cm / 12.4", and as you can see from the screw hole, it can go 1cm shorter. I like a short length of pull because I'm a dwarf or something.
The screw holes are all M4. You will need 45mm screws for the shoulder, and a shorter 35mm for the front. Some washers are a good idea also.