XLR / DMX Connector Lamp

I made this lamp for a friend who is doing light technician as a hobby. The base model came from Hunyuan 3.1, than I added details like the cutout for the light bulbs.

Final Size: About 40cm, good for a desk lamp.

Building:
1. Print the 3 parts, paint if desired.
2. I know it does sound crazy but it works very well: Use hot glue arround the lower ends of the E14 sokets and insert them from the underside to the desired height. Make sure they are straight.
3. Connect the cables correctly and pull the input through the base and the lower part. Dont forget the strain relief.
4. Push the two halfes together. Be careful: the connectors only work once :( For second connection use glue.
5. Put the lamp onto the base by using an M4 Bolt and nut. (might be a litte tricky)

Additional parts needed:
1x M4 Bolt & Nut
3x E14 Lamp, length about 100mm, Diameter about 20mm, e.g. https://www.amazon.de/dp/B0F1D6FJC9
3x E14 Soket Diameter <28mm (most are 25mm), e.g. https://www.amazon.de/QZYIPI-Lampenfassung-Ersatzfassung-Renovierung-Schlafzimmer/dp/B0GVBHQD7P/
2x Wago Connectors, e.g. https://www.amazon.de/Wago-221-415-Verbindungsklemme-5-Leiter-Bet%C3%A4tigungshebel/dp/B0107SYYGU/
1x Input With Switch, e.g. https://www.amazon.de/Anschlussleitung-Schalter-Euro-Stecker-2-polig-Elektroger%C3%A4te-Wei%C3%9F/dp/B0GVSCW1WP
Important: You can get most items in your local hardware store cheaper than the links.
Electrical Connections require expertise, do it at your own risk or seek out to electrician. 

There are only 3 parts, one was 214mm tall, so I reimported it so scale down. You dont need to print the larger lower part.