1 / 9
Front fog light intake adapter Swift Sport (ZC33S) — zdjęcie 1
1 / 9

Front fog light intake adapter Swift Sport (ZC33S)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replaces fog light with and intake duct that can be used for cold air intake or brake cooling

Ocena
0 / 5
Polubienia
12
Pobrania
48
Wydruki
0
Wyświetlenia
429
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

Replaces the OEM fog light with an adapter that can used for ram air to the intake or an adapter for brake cooling (not designed let). It's a modular design for easier printing and will allow you to create custom attachments for things like the brake ducting.

The original intake adapter was made to work with this ram air setup:

but it should be pretty universal in its application.

Installation

  • Remove bumper or wheel liner (refer to manual or something like intercooler fitting instructions)

  • Disconnect and remove respective fog light(s) - keep OEM screws

  • Insert adapter piece making sure to correctly seat in the bumper housing on all edges - it's not perfectly round so may need some flexing

  • Check correct hole spacing and alignment - you will need to mirror model for doing the non-intake side in your slicer

  • [Optional] Insert filter piece if desired

  • Add your adapter - either intake or one of your choice

  • Fit OEM screws loosely to allow adjustment - some larger washers could also help for better strength on the plastic

  • Attach flexible ducting hose (a clamp or cable may be required to fasten firmly)

  • Route to your intake or brake duct setup

  • Rotate the duct as needed and tighten up the screws

Print Settings

  • Material: Reasonably strong but slightly flexible material. I used SBS but PETG is probably a good option. Something too brittle like ABS may brake under strain and vibration but I've not tested.

  • Wall Thickness: 3-5 sidewalls - basically just make sure the actual duct walls and adapter pieces don't have any infill.

  • Layer-height: 0.16 or 0.2 is probably fine, I wouldn't go much higher than that for strength

  • Supports: The curved intake piece will require tree supports - if you're using a straight brake duct attachment then it shouldn't be required

  • Filter (Optional)

    • This is an optional component

    • It consists of two parts, the main outer ring and a solid inner disc

    • The inner disc can be used to apply a per-object slicer infill modifier with 0 top and bottom layers (see image for reference)

The Fusion 360 model is included with most measurements defined as parameters if you'd like to tweak it.

Any feedback welcome.

Tagi