PopMart PopBeans Display Case

This is just a simple display case for your PopBeans, modeled vaguely after PopMart's RoboShop vending machines. 

Each display square is roughly 50x50mm. 

Design prints in several parts, and while the Banner does require an AMS, you can print the case (without the branded bits) without one if you really want. 

If there's interest, I can redo the model so that the top is printable without AMS, but it's an easy 3-color print, and color swaps aren't automatable, but they're limited until the top part so it's not a crazy long print. 

Assembly

Assembly is fairly straightforward, but I've had one question on it so I figured I'd clarify. 

The small pegs are for securing the top "PopMart" banner to the box. They're probably not a super tight fit, but they will help align everything in the case that you want to use superglue to hold the two parts together. If you don't want to use glue, they will at least prevent it from getting knocked off quite as easily. 

Otherwise, the grid insert should fit snugly into the bigger body (see pictures for reference) but note that there are some detents on the sides that should be horizontally oriented. If you look at the sides of the body, you'll see some small dimples halfway up the sides, and the grid insert has corresponding little half-spherical protrusions. Make sure those match up! Otherwise, the fit is meant to be pretty snug, so you may have to press a little bit (hopefully not too much) 

Happy to answer questions if I've missed anything.