1 / 6
Napkin Tray — Toblerone-Style Holder w/ Diamond Cross-Hatch — zdjęcie 1
1 / 6

Napkin Tray — Toblerone-Style Holder w/ Diamond Cross-Hatch

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Upright napkin holder shaped like a Toblerone bar: flat rounded base + two isosceles-triangular side walls leaning in…

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
25
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

A Toblerone-shaped napkin holder — flat rounded base + two isosceles-triangular side walls that lean inward at the peak. Folded paper napkins (~8×16 cm) stack between the walls and lean against them. Single-piece print, flat on bed, no supports.

Geometry

  • Base — 180 × 42 × 3.5 mm rounded rectangle, R6 corners.

  • Walls — two triangles standing on the base's long edges, 75 mm tall at the centre peak, 4 mm thick. The peaks lean toward each other so napkins are clamped between the walls.

  • Decoration — diamond cross-hatch (±45° engraved lines, ~12 mm pitch, 0.9 mm line width, 0.6 mm depth) carved into every visible face: top of the base AND both outer faces of each wall. Reads like woven lattice.

  • No supports: every wall slope is purely in XZ (along the stack axis); each layer is a closed cross-section. Hatch grooves are shallow enough to bridge cleanly.

Print

  • Orientation: base flat on bed; walls grow straight up.

  • Supports: none.

  • Layers: 0.2 mm.

  • Walls: 3.

  • Infill: 15 %.

  • Print time: ~2 h.

  • Filament: ~50 g PLA.

Yellow PLA (shown) makes the hatch lines pop. Looks like a chunky piece of pasta.

Use

  1. Set on the table between people.

  2. Fold paper napkins in half (or quarter, for thicker stacks).

  3. Stack between the walls.

  4. The peaks lean inward, so the napkins stay upright + presented.

Tweaking the SCAD

The parametric variables at the top of napkin_tray.scad cover all the obvious knobs:

  • base_l (180 mm) — adjust for longer/shorter napkin sets.

  • base_w (42 mm) — adjust for thicker napkin stacks.

  • wall_h (75 mm) — taller walls = more capacity, less reveal.

  • hatch_pitch (12 mm) / hatch_lw (0.9 mm) / hatch_depth (0.6 mm) — tune the lattice density.

Files

  • napkin_tray.stl — print-ready single STL.

  • napkin_tray.scad — parametric OpenSCAD source.

Tagi