Wall Hanging Small Plant Terrarium
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small terrarium that attaches to a wall with double sided tape or command strips. Uses plexi sheets for windows.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
A small wall hanging terrarium with a hinged door and removable top. The door and top stay secure with small magnets (5x5mm round for the door, and 3x2mm round for the top).
I designed this to fit these 4x6in plexiglass sheets so that I wouldn't have to do much plexi cutting: https://www.amazon.com/dp/B0BTPH9WLL?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
The front door takes one whole sheet, the sides take a half sheet each, and the top takes about a third of a sheet. So you really only have to make two cuts.
The door hinge uses a piece of standard 1.75mm filament as the pin.
Because of the openings, I found that very particular supports are needed to ensure that the print doesn't fail part way up when the pieces become thin and wobbly. I built removable supports into the design, as well as using tree supports for the top and magnet holes.
The extra supports for the base and front are completely separate, and remove easily. They are just there to help minimize side to side swaying while printing. The supports for the lid are lightly attached and may need a small bit of force to remove.
The back panels are sized to just cover the width of standard Command Strips.