Moose Angled Mag given the Hubris treatment - resized for 256^3 printer size
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Moose Angled Mag resized for 256^3 printer size
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Share Alike
I've been very happy with my remix of the donutcat Hubris mag resized for Bambu print bed size (256mm x 256mm x 256mm). I thought I would seek the same for angled Talon mags.
I found Moose's free angled mag and it's perfect. So:
mag lengthened, and set to print at a 45 degree angle for maximum size
follower slightly modified (narrowed by about 1mm as I found it a little tighter than I prefer)
completely new mag "foot" with the same inside geometry as the mag
As with the Hubris sized for 256^3, I believe this should hold about 27 darts without squishing. Takes one constant force ("drum") spring, such as what Moose sells https://moosemodshop.com/products/drum-springs-magazine-hardware
The foot can potentially stay on with friction only, but I would advise securing it. You can use small screws (approx m2.2 x 6 is an example, but not the only size that would work) or with small pieces of filament.