Arrma Quake Gorgon Fury ESC Motor Cover.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Arrma Quake Gorgon Fury ESC Motor Cover.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 58
- Wydruki
- 1
- Wyświetlenia
- 213
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
UPDATE:
This is a version two update. I recessed the holes where the mounting bolts go through as per resquest. You may print with or without support but I didn't even bother with supports. Also, the vent holes were opened up for better cooling. I never had a temp issue in my testing but it was requested that I open up the breather holes. It was never the intention of this shield to keep dirt and dust away from the motor, that's getting in there regardless. The goal was to stop the sand blasting of my expensive motor, see my picture above. The longer and slightly wider vent hole may allow tiny pebbles in but they definitely won't smash your motor housing and that's ultimately the end goal. More air movement cannot be a bad thing, no!?
Edit-6/18/26: I've taken the new design on a few runs at my usual gravel bash spot. Zero issues with rocks getting into the motor area. Air flow does seem better although I personally had no issue with the previous design.
***Original Upload details***
You're back huh!? Okay, here ya go.
I run a Castle Mamba X with Castle 3800KV sensored motor. My motor/sensor wire were getting absolutely BLASTED by gravel so I made a plate cover. It's a simple cover plate with breather holes. The cover plate was specifically made to accommodate my Castle motor but it will work on your setup as well. I printed mine out of PETG. You can print it solid or try 30% infill. It will eventually crack anyway due to the environment it's in but that's the point. Better the cover getting destroyed than your sensored motor.
You'll need two M3 screws. Top will be longer than the bottom. Top should be around 20mm and bottom around 15MM in length.