QIDI Plus 4 Ultimate Door Seal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A solution inspired by everything I've seen around. Modeled over original cad, fits just right. 90° rotation guaranteed.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 41
- Wydruki
- 1
- Wyświetlenia
- 198
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
BOM | Q.ty |
M3 BHCS any length as long as they reach the metal hinge (for mount-door) | 4x |
M3x25mm OR Ø3x25 M2.5 Shoulder Bolt (for hinge-mount) | 2x |
4mm OD 3mm ID PTFE tube (for hinge-mount) | Short length |
Ø1.5x25mm Dowel Pin (for hinge-strip) | 4x |
M3x6mm (for hinge-joint-strip) | 4x |
(OPTIONAL) M3x0.5mm Shim | 10x |
(OPTIONAL) M3x4.2x3mm Heat-Set Insert | 4x |
!!!IMPORTANT!!! You must slice off the little black spacers' protrusions after removing the original bolts, before installing the mount parts. I pushed an exacto knife against the glass, without removing the spacers.
TIPS & NOTES:
Read the file notes!!!
Do not print out of PLA, use PETG or better. Shrinkage comp. is necessary for ABS, ASA etc;
A fine layer height is recommended to get smooth fillets. If you're still concerned about scratching the front panel, you can tape it up like I did;
Check if the metal hinges are screwed on tight inside the machine before installation;
The PTFE tube acts as a low friction joint between hinges and mounts;
It's best to tighten everything when the printer is in a heat-soaked state;