Simple Golfball-Sized Garden Cane/Stick/Rod Topper - Parametric For Cane Diameter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Make your garden canes safe-topped (no poking your eyes out), coloured to hide or stand out, as required.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a quick fix for a little stub of bamboo which I use to secure a tensioning line for my pond netting because herons would otherwise eat all our fish!
Problem is, I keep tripping over the line or trampling on the cane and snapping it. So I needed something to make it very visible to remind me DON'T STEP HERE!!!
My cane happened to be 12.3mm diameter so that's the STL included here.
If you want to top a cane of any other diameter, just load up the F3D in Fusion and change the FX Parameter "CaneDiam" and it'll take care of the rest. The ball is about 35mm diameter, but that varies a bit depending on CaneDiam. Put in the actual diameter of the cane, and the CAD generates a taper so that the ball should fit the cane about halfway into the hole and then bind, so you just twist it on a bit further and it should grip tight and not fall off, yet be easily removable when wanted.
Any reasonable print settings you want, it's very simple. no support or adhesion, any material at all. Make it a colour that'll blend in if you don't want to see it, for topping support canes etc, or a bright colour if like me you really want it to stand out, hehehe.
Everyone's canes will be different sizes, so there didn't seem much point in uploading a huge selection, just change the parameter.
Please Like this model if you find it useful.
If you REALLY like it, https://www.buymeacoffee.com/gigabeast :o)