Jumper T Pro V2 AG01 nano Gimbals flush adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a flush mount adapter, everything is included and an extra mounting arm depending on how you cut the Gimbals
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Open Community License v1
Flush mount ago1 nano Gimbals for the jumper t pro v2 / v1, all the files needed are in one stl file along with an extra arm just in case it doesn't fit your radio, some this is best to cut one of the cars for a better fit but depends on the ag01 nano revision.
You will need to cut and file the Gimbals along with 2 studs on the radio shell, but no external filing or sanding needed. Also for the electronics side i do recomend reusing the jumper hall sensors if you do have them as it will save you a lot of headaches, you can cut the studs of the sensor holders on the Gimbals and they fit right in with no issues at all.
Note of you are going to use the original ag01 nano sensors the wire polarity in the radio is REVERSED, and please triple check the connections and pin outputs on the radio with a multimeter.
And for firmware well, there is someone out there with a file for the reversed firmware but I lost it I'm sorry in advance.
