[TPU/PLA] USGI 1-Quart Canteen Cap Retainer Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Replacement for your 1-quart canteen's cap retainer. Feedbacks welcomed.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Introduction
Made this to repair my old canteen.
The design with PLA plastic is experimental and probably won't last. I'll update the design when I have time
3D Print Instructions
TPU: Follow your slicer and printer instructions, no support needed, 100% infill, flat side facing the plate.
PLA: Ditto.
Installation Instructions
Remove your old retainer or what's left of it (Both the neck and the cap).
Carefully slide the replacement to the respective locations (larger ring for the cap, smaller for the neck)
Fit the rings inside the groove, you might need to stretch it with a fit of force so it bites into the groove.
Screw in the canteen cap, the retainer should be able to rotate freely if installed correctly.
Enjoy!
Remarks
Feedbacks welcome!