ESP12F RELAY 2X DIN-Rail-Housing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a housing for the popular ESP12F Relay 2x.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
DIN-Rail-Housing for ESP12F RELAY 2X
This is a housing for the popular ESP12F Relay 2x.
It is intended for attachment to DIN-Rails but since the rail-clips are printed
separately it can be used stand alone as well.
Additional parts
part | quantity |
|---|---|
M3x5 cheese head | 2 |
M3x10 cheese head | 2 |
M3x5 counter sunk | 4 |
M3 inserts OD4.5 | 4 |
zip tie | 1 |
Notes:
zip tie is only necessary if an additional gpio-cable will be used
Insert-OD can easily be adjusted to person preference in the FCStd dimensions table
an ods-template to create a matching print label is included in label_ods.zip (ods file format is not supported)
Recommended Print Setting
3 layer shell
13% infill should suffice
support: not neccessary
Orientation
part | orientation |
|---|---|
base | flat side down |
lid | upside down |
clamps | sideways |
Recognition
The DIN-rail clamp was inspired by mdkendalls design.