Qidi Plus4 Ultimate PEI Wiper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A solution inspired by @stew675 's slanted wiper. Modeled from original Plus4 CAD.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
BOM | Q.ty |
M3 Ultra Low Profile, i used 20mm length | 2x |
4mm OD 3mm ID PTFE tube | Short length |
!!!IMPORTANT!!! Despite being modeled from original Qidi CAD, I found that I had to sand the top and bottom surfaces for clearance. I prefer keeping the design as-is rather than taking away layers for it not to match CAD.
TIPS & NOTES:
The plastic parts of the holes are 2.8mm in diameter, you are meant to cut the PTFE tube to lengh (eyeballing it is enough), insert it, then pass a 3mm drillbit through. This ensures a smooth sliding surface for the bolts;
Don't immediately stick the PEI plate after installation. Place it on, and check that the nozzle comes in contact with the PEI and not the printed frame first. Best practice is to do this while the printer is warm and the nozzle is slightly dirty.