Centauri Carbon Canvas ToolHead
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modded the cover so it fits the new Canvas upgrade.
- Ocena
- 5 / 5
- Polubienia
- 28
- Pobrania
- 86
- Wydruki
- 1
- Wyświetlenia
- 970
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a toolhead cover that gave me access to the extruder and would hopefully stop the rattling of the fanshroud. But nothing was compatible with the Canvas unit yet. So , I made some changes to this cover so it fits the new Canvas toolhead.
Printing instructions:
set support to manual
paint support on the areas shown on the images
print
I also added the backbumper and fan fastener made by clogged_nozzl3. On my setup the pins just hold the fan in place, no screws needed, but if you want you can off course add them.
A small magnet on the left screw of the circuitboard on the extruder, wil make the ‘fan not attached’ popup go away.