Boxer Pro+ Kit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A kit to make the boxer pro look and feel much better.
- Ocena
- 4 / 5
- Polubienia
- 16
- Pobrania
- 104
- Wydruki
- 3
- Wyświetlenia
- 621
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — NoDerivatives
Does the boxer pro feel a little underwhelming to you, it sure did for me. With this kit I never felt that way again. No hardware required. Disassembly of blaster required
Instructions:
Handguard:
To assemble the handguard, slide it into the bipod until the bipod can snap into the blaster. This may take a little bit of effort since it's a tight fit. Feel free to increase the size slightly if it's too difficult to slide in.
Carry handle:
The carry handle is simple. Simply remove both the pins holding the feed cover and replace them with the carry handle and carry handle pin. Reuse the same screw used to hold the pins together.
Barrel:
Disassemble the blaster and replace the old one with the new one, simple as that :)
Stock:
Disassemble the blaster and remove the original skeleton stock. Reassemble the blaster and slide in the adapter, should hold together by friction.
Words of Warning
The carry handle will likely wobble around due to the nature of plastic, I didn't feel like trying to fix that :(
Please Please PLEASE! print the barrel in PETG. I printed my barrel in PLA+ and it snapped :(
The stock adapter isn't perfect, and the stock may wobble a little bit. To fix this, just wrap tape around the N-strike adapter and this should fix all your problems.
I didn't test the m60e4 or m249 handguards, but they should still fit just fine.