Colorful Articulated Snake lanyard/keychain with Scales
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Colorful Articulated Snake with Scales and a hole to serve as keychain or lanyard
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 56
- Wydruki
- 1
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I imported the original model into the FullSpectrum fork of Snapmaker OrcaSlicer and painted segments with mixed filaments (two versions, for translucent CMY and opaque RYB filaments).
Finally painted in the eyes just cause I could. Because there is no black with 4 colors, the pupils are brown. Anyone with a five-tool-changer can fill that in with black 😁 Or just sharpie them in.
I do not claim anatomical correctness on pupil shape or placement!
This project was saved with FullSpectrum v0.9.9 and printed on SnapMaker U1 (firmware 1.2.0, I don't think that matters).
No raft, no brim, no supports, no cleanup.
After printing, added a keyring with a carabiner through the mouth so I can attach it to my trousers. Then estimated the length I wanted it to be (to reach my locker) and cut the snake off at that length, adding another key ring instead to attach my keys to.
The current size (83% of the original) should be enough to reach even a high-up locker.
Printer Compatibility
Please be advised that the technique behind Full Spectrum requires even more filament changes than a normal multi-color print, so most people would not advise printing this model on a single-nozzle machine.
A Toolchanger such as the Snapmaker U1 or the Prusa XL is the best machine for this, and even then you have to be aware of the additional wear-and-tear. Please decide for yourself whether a colorful print is worth it! It was for me.
Incidentally, if you do have a Prusa XL with the full five toolheads, you could get even more colors! But I don't, so this 3mf is optimized for a four-head toolchanger with exactly the colors I have loaded 😉
Filaments and colors
You get the best results with decently translucent filament. Polymaker Panchroma translucent CMY filament has proven well-suited, with a more opaque, chalky white.
This "mixes" well at at 0.12 mm layer height printing in about 8 hours.
Because the filament is so translucent, quite a few of the mixes layer solid outer perimeters over inner perimeters of a different color, reducing banding even at higher layer thickness. Hence this project is not suited for opaque color filaments! The white is rarely used in outside perimeters because mine is so opaque.
I also shared a pic of the test palette I printed beforehand to identify good mixes. Yours may very well vary! You should definitely print the palette and fine-tune for your own filaments: