KIA AddGear holder for bin bags and spare bags for the rear seat.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
KIA AddGear holder for bin bags and spare bags for the rear seat, to be used in conjunction with the AddGear cup holder.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 534
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is fitted to the cup holder for the AddGear system in the KIA PV5, which is (usually) supplied with the car.
As far as I know, the cup holder is intended for the rear AddGear place in the middle, and that’s where the bin is supposed to go too. I’ve raised it high enough so that a 10-litre bin bag no longer hangs into the air vents below and doesn’t obstruct the airflow. I’ve used the space gained to store a spare roll of bin bags here. Another advantage of this position is that at least the front passenger can also reach the bin.
As I said, I use 10L bin liners, but larger ones should work too. To improve printability, I’ve split the model into 3 parts (plus the frame used to secure the bag). I’ve glued the bin liner tensioner to the bag holder with superglue, but it should hold reasonably well even without being glued (simple plug-in system).
The anchor is based on the original KIA AddGear part, which can be found here: https://www.kia.com/kr/customer-service/kia-members/kia-addgear/development-ecosystem.
I recommend printing this anchor flat with 6–7 walls. This provides good stability. I used PETG GF; I can’t say anything yet about its stability, particularly in the car – only time will tell.