Climbing Carabiner Anti-Cross Load Stopper for Small Carabiner and Petzl Grigri
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anti-cross load stop for non-gate side of a climbing carabiner for use with Petzl Grigri.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 217
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
Use: This part is designed to be slid onto the non-gate side of a small (non-HMS style) locking carabiner in order for a Petzl Grigri to not accidentally cross load itself while belaying. This is a reasonably common occurrence without this device. This design works well with small style carabiners such as those of the Black Diamond and Petzl brand. I have not tested this with other brands. The fit on large, HMS-style carabiners will be too tight; you don't need to use these large carabiners when using the Grigri anyways as the rope never runs over the carabiner as it would with a tube-style belay device.
Print Material: Some type of FLEX, TPU, or PEBA is best. I like to use TPU 85A but have not tested other materials.
Print Settings: Print this part with all material being perimeters. Set vertical perimeters to 4. Total print time is around 20 minutes for one. You can also experiment with varying degrees of infill.
Disclaimer: Climbing is inherently dangerous. Climb at your own risk. This part is not a life supporting piece of equipment.
