Heewing F-01 - Minimal O4 Lite Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimal solution for mounting the O4 Lite Camera and VTX to the Heewing F-01
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
These two models allow mounting the O4 Lite camera and VTX to the Heewing F-01.
The mount for the VTX includes an antenna mount as well, which corresponds to the pre-scored antenna cutouts of the F-01's foam canopy.
Notes on installation of the camera: the model is currently designed to be used with the default plastic mount that comes with the O4 Lite, and it requires assembling in three steps.
Pull the camera through the camera hole from inside the F-01.
Screw one half of the mount to the camera and push the "back" of the mount back through the camera hole
Push the other half through the camera hole just like you did with the first one, then screw it to the camera as well
You should now have your camera mounted, and the back part should form a "square" that pushes against the inner part of the F-01 camera hole to prevent it from sliding out forwards.
As for the VTX mount, simlply screw the o4 lite onto the 2 holes on the top of the model, specifically on the side that does not have the "feet" with the screw holes. Attach the antenna to one of the two side mounts.
(note I have the camera disconnected in this image to show it better on camera, you would probably want to do this step in the fuselage with the camera attached and already mounted)
Then push the mount up into the front of the nose and screw two screws through the feet into the plywood rail.
