EKET 10 inch 7U rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fully parametric nice looking 10 inch rack in a 1x1 Ikea EKET
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 161
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
With this model you can build a cheap and nice-ish looking rack that's also more flexible than off the shelf alternatives with fixed width.
You'll need an Ikea EKET (25 or 35cm depth, your choice) and 4x 6U or 7U posts (eg https://www.thomann.at/adam_hall_61535b6.htm or https://www.amazon.it/HMF-66806-02-Binario-server-pollici). The .3mf already includes all the pieces, including mirrors, with the right quantities, or you can do it yourself, or customize with FreeCAD if you need to.
This is a fully parametric remix of https://makerworld.com/en/models/2033194-10-inch-eket-rack?from=search#profileId-2192876, I had to make it because I put my EKET in a 30cm Ivar, so it had to be the 25, and with an RB5009 on its rackmount ears, the rails were too far apart for the original model. I tried to improve it where I could, like separating the connector piece for easier layout changes.
I printed it in PETG and using the recommended 3 perimeters 5% infill of the original model.